standard pressure

英 [ˈstændəd ˈpreʃə(r)]

美 [ˈstændərd ˈpreʃər]

网络  标准气压; 标准压力; 标准大气压; 標準壓力

医学

英英释义

noun

• a unit of pressure: the pressure that will support a column of mercury 760 mm high at sea level and 0 degrees centigrade
  Synonym:standard atmosphereatmosphereatm

双语例句

• This paper from the working principle of static expansion method, pointed out the exist problem of the original device, redesigned the major parts and put forward a new way to test the preceding standard pressure.
  从静态膨胀法的工作原理出发，指出原膨胀法测压装置存在的问题，对一些主要部件进行重新设计，提出前级标准压力测定新方法。
• Establishes an empirical formula relating temperature to saturated humidity ratio under standard atmospheric pressure by means of polynomial regression. Analyzes the calculating error in common engineering temperature range, and the error is less than 2.1 percent.
  利用多项式回归拟合了标准大气压下温度与饱和含湿量之间的经验公式，并进行误差分析，认为在工程常用温度范围内，计算误差小于2.1%。
• Development of the Intelligence Standard Pressure Generator
  智能化标准压力源的研制
• The Further Improvement of Some Problems for National Safety Assessment Standard of Pressure Vessel Containing Defects
  进一步完善我国含缺陷压力容器安全评定标准的若干问题
• Just like we referenced everything to one bar before, as our standard pressure.
  就像我们把所有的压强都和一巴作参考，作为标准压强。
• The computer controlled pressure measuring system is composed of a pressure scanning valve and a programmable standard pressure source controlled by a quartz pressure sensor.
  计算机控制的压力测量实时校正系统由压力扫描阀，及石英压力传感器控制的可程控标准压力源等部份组成。在这种系统中，传感器的数量大大减少了。
• Shock tube can be used for standard dynamic pressure calibration equipment except micro-pressure transducers.
  激波管可以作为标准动态压力标准装置（微压传感器除外）。
• By converting test condition to the standard pressure condition, calculation accuracy of average pressure impulse coefficient method is superior to that of tangent method.
  换算到标准压强条件下，平均压强冲量系数法的计算精度优于切线法的计算精度，并作出了计算验证。
• Up till now, in the defect assessment standard of pressure vessel, a semi-experience method, equivalent K ( stress intensity factor) conversion, usually used to deal with beried and surface three dimen-sional crack.
  在压力容器缺陷评定标准中对埋藏和表面三维裂纹问题的处理，通常采用半经验的等应力强度因子（K）换算方法。
• Bronze& One of the first alloys developed in the bronze age is generally accepted as the industry standard for pressure rated bronze valves and fittings.
  青铜是人类在青铜时代发展的最早的合金之一，通常作为压力等级青铜阀门和配件的工业标准使用。